【Command configuration mode】
Global configuration mode
【Parameter】
seconds：Range from 1 to 100 seconds. The default time is 10 seconds
【Usage】
This command is effective when fast leave disables
【Example】
！Configure the max-response-time of igmp-snooping is 99 seconds
QTECH(config)#igmp-snooping max-response-time 99
4.2.5 igmp-snooping fast-leave
Use igmp-snooping fast-leave command to configure fast-leave of the interface.
When fast-leave enables, if the fast-leave message is received, the interface
leaves the aging group, or the time to leave is determined by the
max-response-time.
igmp-snooping fast-leave
no igmp-snooping fast-leave
4-10
To Next Page
Loading...
