QTech QSW-2900 - Show Dot1 X Session

interface-num：Optioned interface number
【Command configuration mode】
Any configuration mode
【Usage】
Use this command to display related information before configuration. Use show
command to display the changes.
【Example】
！Display port-control, re-authentication, re-authperiod and max-user configuration
of ethernet 0/5
QTECH(config)#show dot1x interface ethernet 0/5
8.3.14 show dot1x session
Use show dot1x session command to display 802.1x session, including online
information: interface number, mac-address, username, etc.
show dot1x session [ { interface interface-num } | { mac-address mac } ]
8-39