QTech QSW-2900 - Show Lldp Interface [ <Interface-List

Use lldp command to configure LLDP message receving and sending mode. Use
no lldp command to disable LLDP message receving and sending mode.
lldp { rx | tx | rxtx }
no lldp
【Default】
The default LLDP message receving and sending mode to be rxtx
【Command configuration mode】
Interface configuration mode
【Example】
！Configure e 0/1 only to send LLDP message
QTECH(config-if-ethernet-0/1)#lldp tx
13.1.5 show lldp interface [ <interface-list> ]
Use show lldp interface command to display LLDP information globally or on a port.
show lldp interface [ <interface-list> ]
【Command configuration mode】
13-89