【Command configuration mode】
Global configuration mode
【Usage】
This command should be effective by sending message through multicast
address in anycast operation mode. In order to restrict the range of sending
multicast message, TTL-value setting is suggested.
【Example】
！Configure TTTL-value of sending multicast message to be 5
QTECH(config)#sntp client multicast ttl 5
9.1.8 sntp client poll-interval
Use sntp client poll-interval command to configure poll-interval of SNTP client in
unicast or anycas. Use no sntp client poll-interval command to restore default
poll-interval.
sntp client poll-interval seconds
no sntp client poll-interval
9-9
To Next Page
Loading...
