Default time is 20 minutes
【Command configuration mode】
User mode, privileged mode
【Usage】
If timeout command without parameter, it configures to be default time. No
timeout command means non-overtime. Use no timeout command in telnet, if the
user doesn’t exit and the net is smooth, telnet user is non-overtime; if the net is
disconnected, the link to telnet will be disconnected in 2 hours.
This command is effective for command line users.
【Example】
！Configure the overtime to be 30 minutes
QTECH#timeout 30
！Configure user to be non-overtime
QTECH#no timeout
1.1.15 username username privilege
1-14
To Next Page
Loading...
