QTech QSW-2900 - Garp Permit Multicast Mac-Address

QTECH(config)#show gmrp interface ethernet 0/1 to ethernet 0/3 ethernet 2/1
port GMRP status
e0/1 enable
e0/2 enable
e0/3 enable
e2/1 enable
Total entries: 4
4.2.11 garp permit multicast mac-address
Use garp permit multicast mac-address command to add configured static
multicast group to GMRP to be dynamic learned by other switches.
garp permit multicast [ mac-address mac vlan vlan-id ]
【Parameter】
mac：MAC address of existed multicast group in the form of multicast MAC
address, such as: 01:00:5e:**:**:**
vlan-id：Range from 1 to 4094. Multicast group is combined by vlan-id and mac
4-16