QTech QSW-2900 - Channel-Group Load-Balance; Lacp System-Priority

2.4.3 channel-group load-balance
Use channel-group load-balance command to configure channel-group
load-balance, that is, choose physical link program when message sending.
channel-group channel-group-number load-balance
{dst-ip|dst-mac|src-dst-ip|src-dst-mac|src-ip|src-mac}
【Parameter】
channel-group-number：Range from 0 to 5
【Default】
Source MAC mode
【Command configuration mode】
Global configuration mode
【Example】
！Specify load-balance of channel-group 0 is destination mac
QTECH(config)#channel-group load-balance dst-mac
2.4.4 lacp system-priority
2-38