no channel-group channel-group-number
【Parameter】
channel-group-number：Range from 0 to 5
【Default】
Non
【Command configuration mode】
Interface /Interface group configuration mode
【Example】
！Add Ethernet 0/0/3 to channel-group 3 and specify the port to be active mode
QTECH(config-if-ethernet-0/0/3)#channel-group 3 mode active
！Add Ethernet 0/0/6 to ethernet 0/0/8 to channel-group 2 and specify the ports to
be on mode
QTECH(config)#interface range ethernet 0/0/6 to ethernet 0/0/8
QTECH(config-if-range)#channel-group 2 mode on
2-37
To Next Page
Loading...
