！Configure LLDP hello-time to be 20 seconds
QTECH(config)#lldp hello-time
20
13.1.3 lldp hold-time
Use lldp hold-time command to configure LLDP hold-time. Use no lldp hold-time
command to restore LLDP hold-time.
lldp hold-time <2-10>
no lldp hold-time
【Default】
Default LLDP hold-time is 4
【Command configuration mode】
Global configuration mode
【Example】
！Configure LLDP hold-time to be 2
QTECH(config)#lldp hold-time
2
13.1.4 lldp { rx | tx | rxtx }
13-88
To Next Page
Loading...
