QTECH(config)#mirror source-interface ethernet 0/0/1 to ethernet 0/0/12 both
2.2.3 show mirror
Use show mirror command to display system configuration of current mirror
interface, including monitor port and mirrored port list.
show mirror
【Command configuration mode】
Any configuration mode
【Example】
！Display monitor port and mirrored port list
QTECH(config)#show mirror
Information about mirror port(s)
The monitor port : e0/1
The mirrored egress ports : e0/2
The mirrored ingress ports : e0/2
2-30
To Next Page
