QTech QSW-2900 - Storm-Control

！Display port-isolation information
QTECH(config)#show port-isolation
6.1.7 storm-control
Use storm-control command to configure broadcast/known multicast/unknown
unicast/unknown multicast storm-control. Use show interface command to display
storm-control information.
storm-control rate
target-rate
storm-control { broadcast | multicast | dlf }
no storm-control { broadcast | multicast | dlf }
【Parameter】
broadcast：Configure broadcast storm-control
multicast：Configure known multicast storm-control
dlf：Configure unknown multicast storm-control
target-rate：The target rate of storm-control with the unit of Kbps
【Command configuration mode】
6-8