QTECH(config)#logging timestamps datetime
10.1.9 logging monitor
Use logging monitor command to enable monitor logging and configure filter
regulation. Use no logging monitor command to disable monitor logging and
restore default filter regulation.
logging monitor { all | monitor-no }
no logging monitor { all | monitor-no }
logging monitor { all | monitor-no } { level | none | level-list { level [ to level ] }
&<1-8> } [ module { xxx | … } * ]
no logging monitor { all | monitor-no } filter
【Paramter】
all：All terminals
monitor-no：Means terminal number. 0 means console, and 1 to 5 means Telnet
terminal.
level：Level of information ranges from 0 to 7
none：Any level is not allowed
xxx：Means the name of the module. … means other modules are omitted.
10-9
To Next Page
Loading...
