command, and means all the interfaces of the multicast group in the no multicast
mac-address vlan interface command.
【Command configuration mode】
Global configuration mode
【Example】
！Remove ethernet 0/2 from existed multicast group.
QTECH(config)#no multicast mac-address 01:00:5e:01:02:03 vlan 1 interface
ethernet 0/2
4.1.3 show multicast
Use show multicast command to display the information of the specified or all
existed multicast group.
show multicast [ mac-address mac ]
【Parameter】
mac：MAC address existed in multicast group
4-4
To Next Page
Loading...
