Use keyword “level-list” to display the specified level information in list. If the
“level-list” is not specified, the information of the higher level (The smaller the
level number is, the higher the level is.) and the equal level will be displayed.
【Example】
！Disable flash logging
QTECH(config)#no logging flash
！Configure filter regulations of all terminals to allow all vlan module to output
information
QTECH(config)#logging flash none
QTECH(config)#logging flash 7 module vlan
10.1.14 clear logging flash
Use clear logging flash command to clear flash logging.
clear logging flash
【Command configuration mode】
Any configuration mode
10-16
To Next Page
Loading...
