【Example】
！Clear flash logging
QTECH(config)#clear logging flash
10.1.15 logging host
Use logging host command to configure host ip address, and enable host logging,
and configure filter regulation of Syslog server. Use no logging host command to
remove host ip address, disable host logging, and configure default filter
regulation.
logging ip-address
no logging ip-address
logging host { all | ip-address }
no logging host { all | ip-address }
logging host { all | ip-address } { level | none | level-list { level [ to level ] }
&<1-8> } [ module { xxx | … } * ]
no logging host { all | ip-address } filter
【Parameter】
all：All logging host
10-17
To Next Page
Loading...
