category rules of each subitem is different, and if a packet can match many
rules, there must be a matching order. Use this command to specify the matching
order, whether it is according to user configuration or deep precedency
(precedent to match the rule with the small range). If it is not specified, it is
defaulted to be user configuration order. Once user specifies the matching order
of an ACL, it cannot be changed, unless delete all subitems of this ACL before
respecify the order.
【Example】
！Specify the order to be deep precedency.
QTECH(config)#access-list 1 match-order auto
5.1.7 access-list standard
Use access-list standard command to create a standard ACL with a name ID and
enter standard ACL configuration mode. Use no access-list standard command
to delete one or all subitems of ACL with number ID or name ID or delete all ACL.
access-list standard name [ match-order { config | auto } ]
no access-list { all | { access-list-number | name access-list-name } [ subitem
5-49
To Next Page
Loading...
