upload logging
10.1.1 show logging
Use show logging command to display Syslog configuration, state, and statistical
information.
show logging
【Command configuration mode】
Any configuration mode
【Example】
！Display Syslog configuration, state, and statistical information.
QTECH(config)#show logging
10.1.2 show logging buffered
Use show logging buffered command to display buffered log.
show logging buffered [ level | level-list { level [ to level ] } &<1-8> ] [ module { xxx
| … } * ]
【Parameter】
level：Level of information ranges from 0 to 7
10-2
To Next Page
Loading...
