QTech QSW-2900 - Show Interface

QTECH(config)#show description interface ethernet 0/0/3
【Related command】
description
2.1.9 show interface
Use show interface command to display port configuration.
show interface [ interface-num ]
【Parameter】
interface-num：Means Ethernet port. Interface-num is in the form of interface-type
+ interface-number. Interface-type is Ethernet and interface-number is
slot-num/port-num, in which slot-num is in the range of 0 to 2, and port-num is in
the range of 1 to 24.
【Command configuration mode】
Any configuration mode
【Usage】
If port type and port number are not specified, the command displays information
2-12