QTech QSW-2900 - Permit | Deny

！Create a user-defined ACL with the name to be example and specify the order to
be deep precedency.
QTECH(config)#access-list user example match-order auto
5.1.9 { permit | deny }
Use this command to add a subitem to ACL with the name ID.
1. Add a subitem to standard ACL with the name ID.
{ permit | deny } { source-addr source-wildcard | any } [ fragments ]
[ time-range time-range-name ]
2. Add a subitem to extended ACL with the name ID.
{ permit | deny } [ protocol ] [ established ] { source-addr source-wildcard |
any } [ port [ portmask ] ] { dest-addr dest-wildcard | any } [ port [ portmask ] ]
[ icmp-type [ icmp-code ] ] { [ precedence precedence ] [ tos tos ] |
[ dscp dscp ] [ fragments ] [ time-range time-range-name ]
3. Add a subitem to layer 2 ACL with the name ID.
{ permit | deny } [ protocol ] [ cos vlan-pri ] ingress { { [ source-vlan-id ]
[ source-mac-addr source-mac-wildcard ] [ interface interface-num ] } | any }
egress { { [ dest-mac-addr dest-mac-wildcard ] [ interface interface-num | cpu ] }
| any } [ time-range time-range-name ]
4. Add a subitem to user-defined ACL with the name ID.
5-55