【Parameter】
seconds：Resending interval ranges from 64 to 1024 seconds
【Default】
1000 seconds
【Command configuration mode】
Global configuration mode
【Usage】
SNTP client sends requirement message regularly to the server in unicast and
anycast operation mode. System time will be revised after receiving the message.
【Example】
！Configure poll-interval to be 100 seconds
QTECH(config)#sntp client poll-interval 100
9.1.9 sntp client retransmit
Use sntp client retransmit command to configure retransmit times inunicast and
9-10
To Next Page
