anycast operation mode. Use no sntp client retransmit command to configure
SNTP client not to retransmit requirement message.
sntp client retransmit times
no sntp client retransmit
【Parameter】
times：Times of retransmit ranges from 1 to 10
【Default】
non-retransmit（0）
【Command configuration mode】
Global configuration mode
【Usage】
In order to guarantee reliable transmission of SNTP client, overtime
retransmission system is adopted. The requirement message will be resent if
there’s no reply in a certain time until the retransmit times limits. This command is
effective in unicast and anycast operation mode, because these modes need
9-11
To Next Page
Loading...
