level：Level of information ranges from 0 to 7
xxx：Means the name of the module. … means other modules are omitted.
【Command configuration mode】
Any configuration mode
【Usage】
Use keyword “level-list” to display the specified level information in list. If the
“level-list” is not specified, the information of the higher level (The smaller the
level number is, the higher the level is.) and the equal level will be displayed.
【Example】
！Display the flash log of module vlan
QTECH(config)#show logging flash module vlan
10.1.4 show logging filter
Use show logging filter command to display filter log.
show logging filter { monitor monitor-no | buffered | flash | host ip-address |
snmp-agent }
10-4
To Next Page
Loading...
