QTech QSW-2900 - Sntp Client Multicast Ttl

【Command configuration mode】
Global configuration mode
【Example】
！Configure SNTP client to operate in anycast
QTECH(config)#sntp client mode anycast
9.1.7 sntp client multicast ttl
Use sntp client multicast ttl command to configure ttl-value of multicast message.
Use no sntp client multicast ttl command to restore default ttl-value.
sntp client multicast ttl ttl-value
no sntp client multicast ttl
【Parameter】
ttl-value：Ttl in multicast message sending ranges from 1 to 255
【Default】
Default ttl-value is 255
9-8