QTech QSW-2900

no alarm all-packets
【Default】
Alarm all-packets enable
【Command configuration mode】
Global/interface configuration mode
【Example】
！ Enable global alarm all-packets
QTECH(config)#alarm all-packets
！Enable alarm all-packets of Ethernet 0/0/8
QTECH(config-if-ethernet-0/0/8)#alarm all-packets
2.5.2 alarm all-packets threshold
Use alarm all-packets threshold command to configure alarm all-packets exceed
and normal threshold.
alarm all-packets threshold [ exceed exceed ] [ normal normal ]
no alarm all-packets
2-45