QTech QSW-2900 - Spanning-Tree Mcheck; Spanning-Tree Point-To-Point

QTECH(config-if-ethernet-0/1)#spanning-tree port-priority 64
7.1.8 spanning-tree mcheck
When operation RSTP protocol, and port is in the compatible mode. Use
spanning-tree mcheck command to force the port sent RSTP message.
spanning-tree mcheck
【Command configuration mode】
Interface configuration mode
【Example】
！Configure Ethernet 0/7 to send RSTP message
QTECH(config-if-ethernet-0/7)#spanning-tree mcheck
7.1.9 spanning-tree point-to-point
Use spanning-tree point-to-point command to configure the link connected to the
current Ethernet port to be a point-to-point link.
spanning-tree point-to-point { auto | forcefalse | falsetrue }
no spanning-tree point-to-point
7-11