QTech QSW-2900

【Example】
！Display vct auto-run.
QTECH(config)#show vct auto-run
12.4.11 mac-address-table
Use mac-address-table command to add mac address table. Use no
mac-address-table command to remove mac address table.
mac-address-table { dynamic | permanent | static } mac interface interface-num
vlan vlan-id
mac-address-table blackhole mac vlan vlan-id
no mac-address-table [ blackhole | dynamic | permanent | static ] mac vlan vlan-id
no mac-address-table [ dynamic | permanent | static ] mac interface
interface-num vlan vlan-id
no mac-address-table [ dynamic | permanent | static ] interface interface-num
no mac-address-table [ blackhole | dynamic | permanent | static ] vlan vlan-id
no mac-address-table
【Parameter】
mac：Unicast mac address
vlan-id：VLAN id
12-36