of half, full duplex and auto-negotiation mode. 100 BASE FX supports the speed
of 100Mbps and the duplex mode of full duplex.
【Example】
！Configure the speed of Ethernet 0/0/1 to 100Mbps
QTECH(config-if-ethernet-0/0/1)#speed 100
2.1.13 bandwidth-control
Use bandwidth-control command to control the egress and ingress bandwidth
and limit the total rate of receiving and sending messages. Use no
bandwidth-control command to cancel ingress and egress bandwidth-control
configuration.
bandwidth-control { ingress | egress } target-rate
no bandwidth-control { ingress | egress }
【Parameter】
target-rate：The total rate of bandwidth-control ranges from 64 to 1024000 Kbps
【Command configuration mode】
2-17
To Next Page
Loading...
