When the authentication is successful, user’s privilege is normal. Only when the
authentication reply message includes the field of “service-type”, and the value of
it is “Administrative”, the user is administrator.
【Example】
！Enable RADIUS authentication with the way of PAP
QTECH(config)#muser radius radiusserver1 pap
1.1.10 quit
Use quit command to disconnect with switch and exit.
quit
【Command configuration mode】
Any configuration mode
【Usage】
If the current connect is in telnet, use quit command to disconnect with the switch
and exit. If the current connect is in serial port, after using quit command, you will
re-log in.
1-10
To Next Page
Loading...
