QTech QSW-2900 - Spanning-Tree Forward-Time

Interface configuration mode
【Usage】
Default cost is suggested to use.
【Example】
！Configure path cost of Ethernet 0/8 to 20
QTECH(config-if-ethernet-0/8)#spanning-tree cost 20
7.1.4 spanning-tree forward-time
Use spanning-tree forward-time command to configure the Forward delay of the
switch. Use no spanning-tree forward-time command to restore to the default
forward delay.
spanning-tree forward-time seconds
no spanning-tree forward-time
【Parameter】
seconds： Forward Delay in seconds to be configured. This keyword ranges from
4 to 30 seconds
7-5