Port recover time(second): : 480
Port CAR rate(packet/second): : 300
Port CAR enable port :
e0/1,e0/2,e0/3,e0/4,e0/5,e0/6,e0/7,e0/8,e1/1.
2.4 Port LACP Configuration Command
Port LACP configuration command includes:
channel-group
channel-group mode
channel-group load-balance
lacp system-priority
lacp port-priority
show lacp sys-id
show lacp internal
show lacp neighbor
2.4.1 channel-group
Use channel-group command to create channel group, but there is no member in
the group. To remove the group, all the members of the group must be removed
first. Use no channel-group command to remove the group.
2-35
To Next Page
Loading...
