Use no mirror destination-interface command to remove mirror interface.
mirror destination-interface interface-num
no mirror destination-interface interface-num
【Parameter】
interface-num：Means Ethernet port. Interface-num is in the form of interface-type
+ interface-number. Interface-type is Ethernet and interface-number is
slot-num/port-num, in which slot-num is in the range of 0 to 2, and port-num is in
the range of 1 to 24.
【Command configuration mode】
Global configuration mode
【Example】
！Configure Ethernet 0/0/1 to be mirror destination-interface
QTECH(config)#mirror destination-interface ethernet 0/0/1
2.2.2 mirror source-interface
Use mirror source-interface command to configure mirror source-interface. Use
2-28
To Next Page
Loading...
Need help?
General
