show gvrp
【Command configuration mode】
Any configuration mode
【Example】
！Display the information about GVRP globally
QTECH(config)#show gvrp
GVRP state : enable
3.2.3 show gvrp interface
Use show gvrp interface command to display GVRP information on Ethernet port.
show gvrp interface [ interface-list ]
【Parameter】
interface-list：List of Ethernet ports to be added to or removed from a VLAN. This
keyword needed to be provided in the form of interface-type + interface-number.
Interface-type is Ethernet and interface-number is slot-num/port-num, in which
slot-num is in the range of 0 to 2, and port-num is in the range of 1 to 24. Seriate
3-9
To Next Page
