QTech QSW-2900 - Show Lacp Sys-ID

priority： Range from 1 to 65535
【Default】
Default priority is 128
【Command configuration mode】
Interface /Interface group configuration mode
【Example】
！Configure lacp port-priority of Ethernet 0/0/2 to be 12345
QTECH(config-if-ethernet-0/0/2)#lacp port-priority 12345
2.4.6 show lacp sys-id
Use show lacp sys-id command to display lacp system id, which is in the form of
16 characters of system priority and 32 characters of system MAC address.
show lacp sys-id
【Parameter】
Non
2-41