QTech QSW-2900 - Logging Snmp-Agent

ip-address：Fixed source ip address
【Default】
Not to use fixed source ip address
【Command configuration mode】
Global configuration mode
【Usage】
The fixed source ip address must be the ip address of some port in facility to be
configured, or configuration fails. If the fixed source ip address is not used, egress
interface is used as the fixed source ip address.
【Example】
！Configure the fixed source ip address of logging host to be 1.1.1.2
QTECH(config)#logging source 1.1.1.2
10.1.18 logging snmp-agent
Use logging snmp-agent command to enable SNMP Agent logging and configure
10-21