QTech QSW-2900 - State

QTECH(config-aaa-red.com)#radius host red
【Related command】
radius host（RADIUS configuration mode）
8.1.7 state
Use state command to configure the state of the domain to be active or block.
state { active | block }
【Parameter】
active：active state，allow the authentication of the domain user.
block：block stste，not allow the authentication of the domain user.
【Default】
The default state of the created domain is block, and uses this command to
activate it before use. It is to avoid using the unconfigured domain in configuring.
Activate it after all configuration finished.
【Command configuration mode】
8-9