QTech QSW-2900 - Igmp-Snooping Group-Limit

【Command configuration mode】
Interface configuration mode
【Default】
Fast-leave disables
【Example】
！Enable igmp-snooping fast-leave
QTECH(config-if-ethernet-0/1)#igmp-snooping fast-leave
4.2.6 igmp-snooping group-limit
Use igmp-snooping group-limit command to configure the number of the multicast
group allowed learning.
igmp-snooping group-limit limit
no igmp-snooping group-limit
【Command configuration mode】
Interface configuration mode
【Parameter】
limit：Range from 0 to 128. The default number is 128
4-11