QTech QSW-2900 - Spanning-Tree Priority

7.1.12 spanning-tree priority
Use spanning-tree priority command to configure the priority of the switch in the
specified spanning tree. Use no spanning-tree priority command to restore to the
default priority in the specified spanning tree.
spanning-tree priority bridge-priority
no spanning-tree priority
【Parameter】
bridge-priority：Switch priority to be configured. This keyword rsnges from 0 to
61440，and must be a multiple of 4096.
【Default】
32768
【Command configuration mode】
Global configuration mode
【Usage】
Configure STP priority when STP enables, and the inferior priority of the switch
7-15