Global configuration mode
【Usage】
Overtime retransmit system is used to guarantee reliable transmission of the
requirement message. When there is no reply in retransmit-interval, the
requirement message will be resent.
【Example】
！Configure retransmit-interval to be 10 seconds.
QTECH(config)#sntp client retransmit-interval 10
9.1.11 sntp client valid-server
Use sntp client valid-server command to add a filtration list item of valid -server.
Use no sntp client valid-server command to remove a filtration list item of
valid-server.
sntp client valid-server ip-address wildcard
no sntp client valid-server ip-address wildcard
【Parameter】
9-13
To Next Page
Loading...
