8.3.12 show dot1x daemon
Use show dot1x daemon command to display 802.1x daemon configuration.
show dot1x daemon [ interface interface-num ]
【Parameter】
interface-num：Optioned interface number
【Command configuration mode】
Any configuration mode
【Example】
！Display the 802.1x daemon of all the ports
QTECH(config)#show dot1x daemon
8.3.13 show dot1x interface
Use show dot1x interface command to display such configuration of interface as
control mode, re-authenticate, re-authperiod, max-user, etc.
show dot1x interface [ interface-num ]
【Parameter】
8-38
To Next Page
Loading...
