command on access port. This command configures a default VLAN id for trunk
port，and the VLAN id must be valid, and the port must be in the vlan.
When restoring the default vlan of the port, this port must be in VLAN 1, or the
configuration fails.
【Example】
！Configure default vlan id of trunk ethernet 0/0/1 to be 100
QTECH(config-if-ethernet-0/0/1)#switchport trunk native vlan 100
2.1.19 tag
Use tag command to enable access port to send message with tag vlan. Use no
tag command to disable.
tag vlan vlan-list
no tag vlan vlan-list
【Parameter】
vlan-id ranges from 1 to 4094
【Default】
2-24
To Next Page
Loading...
