Access port can send message with tag vlan of this port
【Command configuration mode】
Interface configuration mode
【Usage】
This command can only be used for access port.
In interface configuration mode, configuration only can enable this port to send
message with specified tag vlan, this vlan can be or cannot be the one the port
belongs to, but the vlan must exist. Tag vlan command can be used for many
times to enable the port to send message with different types of tag vlans. No tag
vlan command has the same way of using, it can enable this port not to message
with specified tag vlan.
【Example】
！Enable Ethernet 0/0/1 to send message with tag vlan 100, VLAN 200 to VLAN
220
QTECH(config-if-ethernet-0/0/1)#tag vlan 100,200-220
2-25
To Next Page
Loading...
