【Default】
All monitor logging disable.
Filter regulations of all terminals are to allow all modules of all levels except level
6 to output information
【Command configuration mode】
Global configuration mode
【Usage】
Use keyword “level-list” to display the specified level information in list. If the
“level-list” is not specified, the information of the higher level (The smaller the
level number is, the higher the level is.) and the equal level will be displayed.
【Example】
！Enable monitor logging
QTECH(config)#logging monitor 0
！Configure filter regulations of all terminals to allow all module of levels 0 to 6 to
10-10
To Next Page
Loading...
