The default order is config order.
【Command configuration mode】
Global configuration mode
【Usage】
This command creates an extended ACL with the name of “name”. After entering
the extended ACL configuration mode, use { permit | deny }command to add
subitem of this ACL (use exit command to exit ACL mode). Each ACL consists of
many subitems, and the specified range of the flow category rules of each
subitem is different, and if a packet can match many rules, there must be a
matching order. Use match-order to specify the matching order, whether it is
according to user configuration or deep precedency (precedent to match the rule
with the small range). If it is not specified, it is defaulted to be user configuration
order. Once user specifies the matching order of an ACL, it cannot be changed,
unless delete all subitems of this ACL before respecify the order.
【Example】
5-44
To Next Page
Loading...
Need help?
General
