【Usage】
This command creates a layer 2 ACL with the name of “name”. After entering the
laye 2 ACL configuration mode, use { permit | deny }command to add subitem of
this ACL (use exit command to exit ACL mode). Each ACL consists of many
subitems, and the specified range of the flow category rules of each subitem is
different, and if a packet can match many rules, there must be a matching order.
Use match-order to specify the matching order, whether it is according to user
configuration or deep precedency (precedent to match the rule with the small
range). If it is not specified, it is defaulted to be user configuration order. Once
user specifies the matching order of an ACL, it cannot be changed, unless delete
all subitems of this ACL before respecify the order.
【Example】
！Create a layer 2 ACL with the name to be example and specify the order to be
deep precedency.
QTECH(config)#access-list link example match-order auto
5-47
To Next Page
Loading...
