【Command configuration mode】
Any configuration mode
【Usage】
This command is used to display ACL runtime application information which
includes ACL name, subitem name and deliver status. If ACL subitem has
been delivered to hardware, the priority of ACL subitem will be diaplayed.
Priority value is from 2 to 13, and there are 5 blocks, interface 1-8 of which
belong to block 0, interface 9-16 of which belong to block 1, interface 17-24 of
which belong to block 2, interface 25 belongs to block 3 and interface 26
belongs to block 4. This command will display the priorities of flow statistics in
5 blocks. Such as the priority of the first 2 blocks is 3, and the priority of the
latter 10 is 5, which will be displayed as 3,3,5,5,5,5,5,5,5,5,5,5. If flow statistics
has only be issued to some block, the priority of the flow statistics in the
current block is displayed, and priority in other block is shown as “/”, such as if
flow statistics is only be issued to block0, and its priority is 8，it will be
5-71
To Next Page
Loading...
