show spanning-tree interface [ interface-list ]
show spanning-tree interface [ interface-list ]
【Parameter】
interface-list：List of Ethernet ports to be added to or removed from a VLAN. This
keyword needed to be provided in the form of interface-type + interface-number.
Interface-type is Ethernet and interface-number is slot-num/port-num, in which
slot-num is in the range of 0 to 2, and port-num is in the range of 1 to 24.
Seriate(sequential?) interfaces with the same type can be linked by to keyword,
but the port number to the right of the to keyword must be larger than the one to
the left of the keyword, and this argument only can be repeated for up to 3 times.
【Command configuration mode】
Any configuration mode
【Usage】
Show spanning-tree interface [
interface-list
] command to display the information
of spanning-tree. Keyword “interface-list” is optional. If it is lacked, information of
interfaces is displayed, or only the information of specified interface is displayed.
7-2
To Next Page
Loading...
Need help?
General
