！Configure the priority of port 2 in instance 1 to be 16
QTECH(config-if-ethernet-0/0/2)#spanning-tree mst instance 1 port-priority 16
7.2.9 show spanning-tree mst config-id
Use show spanning-tree mst config-id command to display MSTP config-id.
MSTP config-id includes: MSTP revision level, MSTP config-name and the
mapping relations between STP instance and VLAN.
show spanning-tree mst config-id
【Command configuration mode】
Any configuration mode
【Example】
！Display the config-id
QTECH(config)#show spanning-tree mst config-id
7.2.10 show spanning-tree mst instance interface
Use show spanning-tree mst instance command to display port information in
some instance.
7-29
To Next Page
Loading...
