The way to obtain IP address are by BOOTP、DHCP、and manual operation. If
dhcp enables, the switch will obtainn the ip address by dhcp, and bootp or manual
operation will be error. If bootp is wanted, input no dhcp first，then input bootp.
【Example】
！Enable DHCP to obtainn IP address
QTECH(config)#dhcp
12.4.4 dlf-forward
Use dlf-forward command to enable dlf forword. Use no dlf-forward command to
disable dlf forward.
dlf-forward { multicast | unicast }
no dlf-forward { multicast | unicast }
【Parameter】
multicast：Multicast message
unicast：Unicast message
12-29
To Next Page
Loading...
