QTech QSW-2900

2.4.5 lacp port-priority.........................................................................2-40
2.4.6 show lacp sys-id........................................................................2-41
2.4.7 show lacp internal......................................................................2-42
2.4.8 show lacp neighbor ...................................................................2-43
2.5 Port Alarm Configuration Command....................................................2-44
2.5.1 alarm all-packets .......................................................................2-44
2.5.2 alarm all-packets threshold .......................................................2-45
2.5.3 show alarm all-packets..............................................................2-46
2.5.4 show alarm all-packets interface...............................................2-47
Chapter 3 VLAN Configuration Command .................................................. 3-1
3.1 VLAN Configuration...............................................................................3-1
3.1.1 description...................................................................................3-1
3.1.2 show vlan.....................................................................................3-2
3.1.3 switchport ....................................................................................3-3
3.1.4 vlan..............................................................................................3-5
3.2 GVRP Configuration Command ............................................................3-7
3.2.1 gvrp..............................................................................................3-7
3.2.2 show gvrp....................................................................................3-8
3.2.3 show gvrp interface .....................................................................3-9
3.2.4 garp permit vlan.........................................................................3-10
3.2.5 show garp permit vlan ............................................................... 3-11
3.3 QinQ command ...................................................................................3-12
3.3.1 dtag............................................................................................3-12
3.3.2 dtag mode..................................................................................3-14
3.3.3 dtag insert..................................................................................3-15
3.3.4 dtag pass-through......................................................................3-16
3.3.5 rewrite-outer-vlan ......................................................................3-17
3.3.6 vlan-swap ..................................................................................3-18
3.3.7 show dtag ..................................................................................3-19
III