Chapter 4 Configuring Your Library
Managing Connectivity
Scalar i2000 User’s Guide 133
4 Click Setup→ Connectivity→ FC Host Port Failover.
The FC Host Port Failover dialog box appears, showing all the I/O blades
found in the library. Each blade is identified by name and by location.
5 Click a blade to highlight it, and then click Configure.
The FC Host Port Failover dialog box appears
6 In the Feature Enable area, select Enable FC Host Port Failover, and
then click Set to make the Configuration tab available.
On the Configuration tab, settings are unavailable if the current state of
the tab is set to Disabled.
To Next Page
Loading...
